Andis Phenom™ Replacement DLC T-Blade (562322) — Deep-Tooth Zero-Gap T-Blade for Phenom Trimmer (FRS-T)

Restore factory-fresh precision — Andis Phenom Replacement DLC T-Blade (562322)

Give your Phenom the pro-level edge it deserves. The Andis Phenom Replacement Deep-Tooth T-Blade (562322) is built for barbers who demand razor-sharp outlines, clean lineups, and effortless detailing. DLC-coated stainless steel reduces heat and friction, runs cooler under long sessions, and holds an edge longer — so your fades stay flawless and your work stays fast.

Why barbers upgrade to this blade

• Deep-tooth T-blade — improved hair feeding for smooth, snag-free detailing and crisp lines.
• DLC coating — harder surface, lower friction, better heat resistance, extended edge life.
• Zero-gap capable — dial in ultra-close cuts when aligned properly for clean necklines and designs.
• Perfect fit — designed to fit the Andis Phenom Trimmer (Model FRS-T) exactly.

What it’s good for

• Outlines, necklines, and crisp edge-up work
• Designs and detail trimming
• Barbers running long shifts who need cooler blades

What it’s not ideal for

• Not a full clipper blade — not intended for heavy bulk cutting
• Ceramic/DLC blades are harder — avoid dropping or striking on hard surfaces

Specifications

• Part / Model: 562322
• Compatibility: Andis Phenom Trimmer (FRS-T)
• Blade Type: Deep-tooth T-blade, zero-gap capable
• Material / Finish: Stainless steel teeth with DLC coating
• Includes: (1) Replacement Deep-Tooth T-Blade (562322)

Installation & Quick Tips

1. Power off and unplug the trimmer before servicing.
2. Remove the old blade, position the new blade flush and square, lightly tighten screws.
3. Align carefully — zero-gap only after verifying the moving blade never extends past the fixed blade.
4. Test on arm hair or scrap paper to confirm alignment before client use.

Maintenance

• Brush away clipped hair after each use.
• Apply a few drops of blade oil along the teeth and rails daily with heavy use.
• Disinfect per shop protocol between clients.
• Replace when you notice decreased cutting performance or visible wear.

FAQ

• Will this fit other Andis trimmers? It’s specified for the Andis Phenom Trimmer (FRS-T). We recommend using this blade for that model only.
• Can I zero-gap this blade? Yes — it’s zero-gap capable. Proceed carefully: improper alignment can cause nicks.
• Does DLC run cooler? DLC lowers friction and improves heat resistance compared to untreated steel — still oil regularly for best results.